CM570 reprograming

[Rawze]

(07-26-2021 )Tcarothers Wrote:  Rawze, thank you for the link. Made for some good reading. The Cummins shop that is doing the programing will be getting the info off my old ecm and wanted the vin of the Volvo and all the engine numbers off the valve cover to make sure they get the right programing not only for the motor, but for the entire truck. I was just wondering if their was a way to bump it up, but i am fully satisfied with the stock parameters. Thank you again

It is best to stay with the program that is made for the engine and truck piping ... You could always however pull a copy of the program out of the ecm and e-mail it to someone to have only the flywheel torque/power settings bumped up a bit.

It being a CM570, make sure it does not over-boost... should be about 37psi or so max at the extremes.