Oil leak on backside of motor

[Chamberpains]

I would say this is much better buuut... Pad the dipstick tube where it's resting against the frame and zip tie it to the hose clamp. Also if that purple air line is flopping around anywhere and rubbing against anything like that bunch of wires in the loom, then pad it there and zip tie it fast also.

Your clutch linkage pivot points look dry. Throw some grease at them and some dry lube or anti-sieze at the steel pins. Hopefully you know there is also another pivot point way underneath the cab that has a grease zerk. It's above the clutch cross shafts attached to the bottom of the cab. I found mine when I had the transmission out other than that I would've never noticed it could take grease.

Also make sure your greasing the upper and lower ujoints on the steering shaft. I found after taking the truck to the speedco for a quick grease job, they never touched any of this stuff. I've asked many people if they knew about these grease points and they had no clue they where there or if they had ever greased them.