Cm2250 nox sensor power wire failing load test

[Gcc]

Ok so I just double checked and realized that I must have had a bad groubd on other side of test light as it stays nice and bright. I hace fault code 3232. Spn 3216. Fmi 9. And a derate active. I have replaced inlet and outlet nox sensors, dpf differential pressure sensor, egr differential pressure sensor, egr orfice sensor, exhaust back pressure clean imap which wasn’t bad, replaced dpf doser and def doser. I notice that it only throws code under full throttle applications when the truck hits 580+ egt and then soon as temps drop back down 425-450 light goes out again its the only correlation I’ve been able to find. The fuel punp come on with key on for 30 seconds then it shuts off sound nice and health fuses are all good I’m probably missing something but dont know what and I cant get the dash to stop saying regen require even though a regen comes back what I think is decent compared to what I’ve read my differential is normally .1 after a regen I’m thankful for anything people can offer