ABS Sensor connector

[Truckdriven]

Thanks to all for your info. I google searched "APE-P2P" and and found this website https://www.dtnaecomponents.com/Connecto...152216.htm This turned out to be Freightliner part numbers and I was able to find them on eBay for around $100. Yes its expensive but I can repair the harness to %100 factory condition and far less then replacing the entire harness which was the only solution from Kenworth. Next question, the instructions with the new sensor say to slide the sensor in until it contacts the tone ring. My thought is that will rub on the sensor shouldn't it be backed off just a little bit? What is the proper way to install these??