Rawze.com: Rawze's ISX Technical Discussion and more / Big Truck Technical Discussion... / Ask Your question... / Overhead

new reply
Overhead
09-11-2016, (Subject: Overhead ) 
Post: #6
Contributing V.I.P.Signature620 Offline
Contributing V.I.P.  (840 Likes)  ****

 		Posts: 737
Joined: May 2015
Thanks: 625
Given 840 thank(s) in 449 post(s)
RE: Overhead
Do they have a lot of travel between detent position and the cam lobe? Sounds like you need to loosen the rocker shafts and rotate them to bring the jake running clearance back into the correct range. I can post the procedure if you don't have access to Quickserve.
Return to Top | find
replyreply
new reply


Messages In This Thread
Overhead - dbl overdrive - 09-11-2016,
RE: Overhead - Signature620 - 09-11-2016,
RE: Overhead - Hammerhead - 09-11-2016,
RE: Overhead - Rawze - 09-11-2016,
RE: Overhead - dbl overdrive - 09-11-2016,
RE: Overhead - Signature620 - 09-11-2016
RE: Overhead - Rawze - 09-11-2016,
RE: Overhead - dbl overdrive - 09-11-2016,
RE: Overhead - Rawze - 09-11-2016,
RE: Overhead - dbl overdrive - 09-11-2016,
RE: Overhead - Rawze - 09-11-2016,
RE: Overhead - dbl overdrive - 09-11-2016,
RE: Overhead - dbl overdrive - 09-11-2016,
RE: Overhead - Signature620 - 09-11-2016,
RE: Overhead - dbl overdrive - 09-24-2016,



NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.
Theme by MyBB Addict
Contact Us | Rawze.com | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication