Adventures with a Pete 587 |
11-02-2022, (Subject: Adventures with a Pete 587 ) Post: #14 | |||
| |||
RE: Adventures with a Pete 587 I think you got a king pin that was to big. It absolutely shouldn't go in that hard. Did you check the fit of the pin into the axle eye without the spindle before you put it all together? Also did you mic the axle eye bores to check for excessive wear? A lot of times (unless the truck is less than 5 years old) your axle eyes are wore out and need resleeved if the king pin comes right out with little effort. Who reamed the spindle bushings for you? | |||
|
« Next Oldest | Next Newest » |
Messages In This Thread |
Adventures with a Pete 587 - JimT - 01-11-2020, RE: Adventures with a Pete 587 - Mattman - 01-11-2020, RE: Adventures with a Pete 587 - JimT - 02-21-2020, RE: Adventures with a Pete 587 - Magard - 02-21-2020, RE: Adventures with a Pete 587 - JimT - 02-21-2020, RE: Adventures with a Pete 587 - Nilao - 02-21-2020, RE: Adventures with a Pete 587 - JimT - 02-21-2020, RE: Adventures with a Pete 587 - Rawze - 02-21-2020, RE: Adventures with a Pete 587 - Rawze - 02-21-2020, RE: Adventures with a Pete 587 - Mattman - 02-21-2020, RE: Adventures with a Pete 587 - JimT - 06-19-2020, RE: Adventures with a Pete 587 - JimT - 06-19-2020, RE: Adventures with a Pete 587 - JimT - 11-01-2022, RE: Adventures with a Pete 587 - tree98 - 11-02-2022 RE: Adventures with a Pete 587 - JimT - 11-02-2022, RE: Adventures with a Pete 587 - tree98 - 11-02-2022, RE: Adventures with a Pete 587 - JimT - 11-02-2022, RE: Adventures with a Pete 587 - Nilao - 11-02-2022, |
NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.