Turbo clamp soot

[Rawze]

Mine requires an 11mm deep well socket to tighten it. -=- 95 in-lbs. is max torque allowed on mine (500-series VGT).

Maybe tighten it to 90 in-lbs.. smack the clamp around it, best you can, a few times with a hammer and a soft brass bar or something ... then re-torque it back to 90 ~ but no mroe than 95 in-lbs.

Make sure you use an accurate in-lbs (not ft-lbs) torque wrench if you set it at 95.


What little bit it appears in the photos so far is likely no big deal though.. unless it starts getting really sooty.