DIY Flywheel housing gasket/clutch/RMS

[Ricky]

(05-18-2023 )dhirocz Wrote:  It’s time. 130k after my inframe and the flywheel housing gasket…or the rear main…is leaking quite a bit. I knew it was coming, so I call to schedule my truck in for that and a clutch too. I think 8 years is a good enough lifespan for one…
…then Haggais tells me they downsized and are no longer taking flywheel housing gasket jobs. Well now I’m back to the drawing board, I’ve never taken my truck to a shop but I was planning on farming that one out.
I’m not aware of anyone in the SE that does work like this that is trustworthy, so I guess it’s time to roll up my sleeves again. Im drawing a blank on the best approach to do this. Tools I have, what I don’t have is heavy equipment like a chain hoist or a trans jack for trucks, though Im never opposed to buying more tools. I know there are some people who do these things like they are candy…Im more worried about it being done correctly.
Who here has done this? Any advice would be great…

Not sure where you are at but there's a place in St Pauls NC ...
{PM user for the info.}