ISX 11.9 Code 3232

[Rawze]

When you connect Insite software, what program does it say in the title bar is in the ECM?. 'CL10??.??'

The wrong program in the ecm due to some moron trying to 'up the hp' incorrectly will make for ghost error like this for sensors etc.

and has anyone bothered to ohm out the J1939 properly??.
ref: http://rawze.com/forums/showthread.php?t...6#pid67656

Also, it can be the wrong part# for the replacement, or if it is an after-garbage component, then it might have the wrong J1939 address assigned to it. That is a possibility as well.