ISX 11.9 Code 3232

[TBird556]

(10-10-2023 )Rawze Wrote:  When you connect Insite software, what program does it say in the title bar is in the ECM?. 'CL10??.??'

The wrong program in the ecm due to some moron trying to 'up the hp' incorrectly will make for ghost error like this for sensors etc.

and has anyone bothered to ohm out the J1939 properly??.
ref: http://rawze.com/forums/showthread.php?t...6#pid67656

Also, it can be the wrong part# for the replacement, or if it is an after-garbage component, then it might have the wrong J1939 address assigned to it. That is a possibility as well.

CL10064.45 is what’s in the ECM, which is what the ESN requires. Have extensively tested the 1939 network, and power and ground to inlet NOX we hooked up a fog light and a backup alarm to confirm wires can carry a load even after good ohm testing.
Has anyone seen faulty Cummins RX inlet Nox sensors out of the box?