Isx15 2250 choking

[NDISX15]

(12-11-2023 )Samvelm83 Wrote:  

(12-11-2023 )Rawze Wrote:  Just some speculation...
could also be the the turbo locked up at 100% closed, choking the exhaust so badly that it cannot stay running.

someone could test this by removing the fitting/pipe clamps and bellows (or at least make a gap) where the manifold makes a u-turn and goes into the egr cooler. Open up the exhaust manifold so that it can breathe ... and see if the relieved pressure from the manifold allows the engine to keep running.

If the turbo is locked up then the acutator would throw an error code, right?

Not necessarily. I've seen many turbos/VGT Actuators fail in 90+% closed positions before and never trip a light/code. Last one I saw was 100% locked closed and only way we got it to run long enough to get it indoors was to pull the bellows off the manifold to the EGR cooler so it could breathe. Pulled the actuator and the turbo VGT was seized at 93%. If it starts and runs after removing that bellows, pop the VGT actuator off and verify the position of the turbo. Or try to run the VGT Hysterisis test in Instite.