VGT actuator faults paccar mx13 epa13

[ktblogistics]

think the vgt actuator is bad, you need insite to make simple hysterisis test to see if it passes, when i had no pass mostly it was stuck vgt motor inside, unplug connector and connect again with key on and see if it selfchecks, ive replaced a few with miles between 100-200k on local trucks with heavy idling, if you want to remove actuator you need insite but should know this from mentioned movies already, part is not cheap around 1800 but with software you can check it quickly, at place i work it is very common problem for L9 cm2350 paccar, dont know why but we replace a lot of actuators if you compare to number of serviced trucks, hope this helps

edit you have mx13 i thought about px9