PETE 587 ISX15 EATON ULTRASHIFT Jumping/shaking really bad when placed in drive

[Alexp86]

(01-25-2024 )Rawze Wrote:  

(01-25-2024 )Alexp86 Wrote:  

(01-25-2024 )Rawze Wrote:  keep a close eye on the engine rpm. Is it floating around or creeping up?.

What rpm is the engine set at for idle?.

When it did it yesterday I did notice on startup it was 1 higher around 8 for about 5 seconds and it dropped. Its normally a hair bellow 7, 690.

DO an injector leak test on it to see if it will pass.
ref: http://rawze.com/forums/showthread.php?t...3#pid75483

Also, the rpm for most auto-s$itter trannies needs to be below 650rpm for them not to get jumpy and want engage like that.

Engine could be idling up on its own due to leaky injector(s) or the fuel pedal acting up.

Are you letting those idiots at the truck wash places wash under the hood?... That IS A BIG NO-NO!. and will cause the fuel pedal to randomly act up among other problems, especially so on Pete's and KW's.

Ok I will try that. I just got the software im ordering the cables today. I did lower the rpm to 650, any lower was feeling like it was going to stall, but it didint jump at all today. It could be a coicedence as it doesnt happen everyday, but ever since they changed the carrier bearing the jump has been more violent.
I also cleaned the plugs on the passenger side hopefully it was something that simple.

No ive never let anyone wash my engine although when the wash the truck it drips cause they have the hood up whos to say it didint splash where it wasnt supposed to.