IInjector driver codes

[JRTRK]

(05-22-2024 )JRTRK Wrote:  

(05-22-2024 )tree98 Wrote:  Will it pass a rail pressure leakdown test? The one in insite not just turning the engine off and watching the pressure.

It's possible your new ECM is garbage. Is it a genuine Cummins part or some rebuilt garbage can from God knows where?

Just curious about this head gasket. Did you just replace the head gasket and that's it ? This wasn't a full inframe?

What is the actual code/codes it was showing?

Yes it passes the one in insite where it bumps the psi up to roughly 30k. This is a de mandated Cummins. We got a blank EMC right from peterbilt. The exact parameters were taken out of the old ecm and put into the new one. The codes are 0324 and 0325

This was not a inframe, this truck came in with a blown head gasket, we did a head gasket measured liner protrusion the whole 9 as far as what you can measure when takeing the head off these, and then he came back with this problem. In my opinion I don’t think the two are related and just a coincidence