Jake switch settings in Esa

[mp7]

(10-30-2024 )Rawze Wrote:  - What should have happened is that the original CM2350 ecm and wiring harness be re-used on the new long block instead of trying to wire up the whole ecm, etc. Then a custom program made to run that newer hardware on the older model ecm.

yes in further research after the fact that is what sounds to have been a better plan. but the owner of the truck had the ecm tuned and was told it would work, and we were not supposed to have to deal with any of this and just do the engine replacement but now we have these issues and said "tuner" cant figure it out and the truck owner asked if I could try to figure something out. Id post up the tune file for shi#t talking opportunities but I dont have the right econfg file