Jake switch settings in Esa

[mp7]

(10-30-2024 )Btech Wrote:  In Insite Under parameters,
Clutch position switch - installed
Parking brake switch - enable
Service brake switch - enable
These are parent settings separate from the next list which are nested under the following.

Under SAE J1939 Multiplexing

Clutch pedal position switch - enable
49 - cab controller primary

Cruise control on/off switch - enable
49 - cab controller primary

Cruise control set/resume switch - enable
49 - cab controller primary

Engine brake switch level - enable
49 - cab controller primary

Idle validation switch - disable

Parking brake switch - enable
49 - cab controller primary

Service brake switch - enable
49 - cab controller primary

In ESA engine brake level switch should be set for 0/33/66/100

That's how I've got it set now. Minus the park brake setting doesn't exist in sae multiplex on this unit