CM870 ECM AND TURBO PROBLEMS

[1693rattler]

Thanks Rawze. I'll check the ecm part numbers, replace the turbo and get with running rough. I actually ended up pulling the engine when I saw what bad shape it was in and rebuilt everything. I don't think anything wasn't leaking oil. Both cams had lobe damage and were replaced as well as the rockers. Reman oil pump, water pump, air compressor, injectors, oil cooler replaced and new damper. The block had to be cut and the liner protrusion was double checked before the head went on. New jake harness under valve cover, solenoids passed the ohm test but I did change the orings. I'm too deep in this project to not finish it right!! Thanks again.