(01-09-2025 )Bigballercarhauler Wrote: (01-09-2025 )Rawze Wrote: brass shims have about 0.001" crush after head install ... pretty consistently.
They checked heights with .007 on 3-6 all of which barely or wouldn’t get under with the feeler gauge. They def sunk on all those cylinders
its got 440k on it the block should be cut but that is not a very accurate way to measure liner height... gasket material still on the block using a piece of metal not known to be perfectly flat that has hammer marks in the middle liners not clamped down don't get me wrong they are likely to low your measuring to .000 not whole inches dial indicators are cheap get one
(Online)
