| ISX Cm871 cutting out |
| 02-17-2025, (Subject: ISX Cm871 cutting out ) Post: #2 | |||
| |||
RE: ISX Cm871 cutting out (02-17-2025 )08kent800 Wrote: I have a 2008 kenworth T800 that I recently bought and it has the ISX Cummins in it. I’m having trouble with it cutting off when under acceleration. When it’s cold and you first start it up and start driving the rpm will not read over 1000rpm after it cuts off once while driving the rpm will read correctly and sometimes once it cuts off the next time it won’t read at all. I’ve tried the tap test on the ecm and it won’t cut off from being tapped on. And I found that one of the main 2 main power wires in the 4 pin connector doesn’t have power the grounds are good and the other wire has good power. I traced the wire back to a fuse just below the ecm and the fuse is good and the circuit reads good to there but I can’t find where the wire goes to from there. might be similar issue to this?... ref: http://rawze.com/forums/showthread.php?t...05#pid3505 User's Signature: ->: What I post is just my own thoughts and Opinions! --- I AM Full Of S__T!. | |||
| « Next Oldest | Next Newest » |
| Messages In This Thread |
ISX Cm871 cutting out - 08kent800 - 02-17-2025, RE: ISX Cm871 cutting out - Rawze - 02-17-2025 RE: ISX Cm871 cutting out - 08kent800 - 02-17-2025, RE: ISX Cm871 cutting out - tree98 - 02-17-2025, RE: ISX Cm871 cutting out - 08kent800 - 02-19-2025, RE: ISX Cm871 cutting out - 08kent800 - 03-24-2025, |
NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.