QSC8.3 CM554 CAPS - How to get .xcal file

[J99]

Thanks for the reply. Here are more precisions :
- The engine refuses to start despite checks on lift pump pressure (10 to 15 PSI as per spec), on gear pump pressure before the CAPS pump (around 165 PSI when crannking, as per spec), and whereas it was running fine the day before. The main change done before was changing the lift pump as the older one was clogged (algues). And we believe the new lift pump created some trouble of over / under tension in the ECM as it was not willing to run just on ECM 12V at some times (despite running well on 12V on a battery). It appeared to need more Intensity, consuming more watts. Now we cleaned the old one and put it back, works more normally with the 30 sec temporization with key on.
- I am able to connect to the ECM with Insite 7.5, was able to create a work order, an ECM Image, save it as a template, and check all fault codes (main one remaining from last time engine was running being 268 which indicates as first possible root cause that ECM may need to be recalibrated).
- I tried to resend the ECM Template to the ECM, works but no change.
- But one or two times during my connections to ECM, Insite sent a pop up with Error 5081 "Insite has detected some ECM have an invalid footprint and must be recalibrated"...I was able to temporarily make it dissapear by reloading the ECM Template taken on the ECM, but it looks to not be enough.
- So I am willing to recalibrate (I guess that is what you call reflash).
- I tried unzipping with 7zip and it is asking me for password, but I don't know where to find those passwords. Can somebody help me here ?
- For the ecfg/e2m files, I have some for the QSC8.3 from Libraries from CalTerm, but not sure which one is for my CM554 : Any idea on how to make sure of this ?

Thanks