12.7 60 series no start |
03-17-2025, (Subject: 12.7 60 series no start ) Post: #3 | |||
| |||
RE: 12.7 60 series no start Thinking out loud, are you able to see in DDDL if the Sync Reference Sensor (SRS) Recieved is reading Yes/No when cranking? Otherwise, ohm out the injector harness at the ECM for a possible injector harness shorted out to the cylinder head. Lastly, I believe the Timing Reference Sensor (TRS) is shimmable if you don't have enough sensor gap. If you could find a known good waveform for the SRS and TRS you could hook up an oscilloscope to both of them and rule out sensors not reading properly. Edit: Thinking about it too, the crank sensor has no missing teeth, so an oscilloscope would be able to confirm signal integrity but wouldn't be able to verify timing in spec. | |||
« Next Oldest | Next Newest » |
Messages In This Thread |
12.7 60 series no start - eggtrucks - 03-17-2025, RE: 12.7 60 series no start - Rawze - 03-17-2025, RE: 12.7 60 series no start - Notch - 03-17-2025 RE: 12.7 60 series no start - Btech - 03-17-2025, RE: 12.7 60 series no start - eggtrucks - 03-18-2025, RE: 12.7 60 series no start - eggtrucks - 03-18-2025, |
NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.