Threaded Mode | Linear Mode

Rawze

(04-24-2025 )Mcwrench94 Wrote: Im curious if there are better programs to compare cummins xcal calibrations other than calterm?
Im a novice at best, just trying to learn. Maybe im not using calterm right but when im using the compare feature on isx cm2350 alot of the parameters are x’d out?

Trying to learn the programming by doing compares of other peoples work is an utter, complete waste of time. This especially if your using CT to do them, as it is absolutely horrible for this.

What your doing is also the equivalent to trying to figure out the recipe for a special type of bread.. and all you have is the already baked result.

YOU LITERALLY are seeing LESS THAN HALF the changes actually needed, and will never get a complete picture of what your trying to learn by sifting thru compare reports.

This is how you learn this stuffs properly... (about mid way of this post)...
ref: https://rawze.com/forums/showthread.php?...2#pid83452