N14 Celect Plus PTO mode question

[Torqueturn]

(09-16-2025 )Btech Wrote:  On a celect plus if the PTO RPM limit is set high enough with cruise switch on you have to hold the resume switch to increase RPM and hold the set switch to decrease RPM, it's about a 4 second hold of the switch before the ECM will start changing the RPM.

Finally had a chance to get back to this.

I am embarrassed to admit this is exactly what it is hahaha

It was deceiving because the Celect was an instantaneous ramp up so definitely didn't think to hold switch for a few seconds

Tee'd a set of wires into the cruise switch and put a second switch in the back

Thanks for the info