Cm871 rebuild

[Rawze]

- Tell the person to cut it so that all liners are at 0.015"... accurately to within 0.001" for all, and 0.001" or less error from 1 - 6 final heights between all. - Tell him that its not his job to warranty your engine anyways. - Make him verify the heights for all liners measuring all depths .. then again with 100 ft.lbs torque on each liner to verify heights with you before he leaves, ... take pics of all heights and measurements.. and everyone is happy. - His part is done.

info: https://rawze.com/forums/showthread.php?...6#pid70606

(assuming you live in a foreign country)...
== As far as block plates go..one at the intake where the venturi meets the intake manifold.. and another one between exhaust manifold @ cylinder #1 and inlet of the the egr cooler.

== ALL cans under truck hollow 100% to the bare metal.

== Crank case filter replaces with maintenance-free version (the one with 2" hole thru it and no element).

PULL the ecm file and e-mail it to me for a review of what someone did in there. More than 90%+ of all delete programming is BAD... HARMFUL KIND OF BAD!!!... make sure its not eating the guts out of the engine slowly over time.