Made in Germany angle grinders

[mikkhh]

Sparsely used quite new angle grinders that did not last as long they used to.

Control board failed on quite new one - most likely x2 safety capacitors faulty - BUT is glued in epoxy and no easy fix, bought new board for 35euros.

Second one has worn bearings - BUT you can not replace just bearings since the bearing is casted in plastic and must buy 20euro part instead of just 2 euro bearing.








I had similar issue on my Italian company eccentric car polisher, new tool was 400 euros, control board was 100 euros + shipping 20 euros, in that case I just carved away the epoxy with care and replaced x2 capacitor + electrolytic capacitor.