| Flash old ecm to new ECM |
| Yesterday, (Subject: Flash old ecm to new ECM ) Post: #1 | |||
| |||
| Flash old ecm to new ECM Its been awhile since I've needed any help. But, today I had my truck break down 3 hrs away from home. 2010 Kenworth T660 CM871 with a mommaburt tune demandate done years ago. Fan circuit code isn't letting the truck start. Unplug the fan solenoid and code goes away. But the truck won't start. Crank no start. Put a jumper wire in the plug and the code comes back. I suspected the ECM so i tapped on it and nothing makes this clear up. I have sourced an ECM 3 hrs away and Kenworth is going to put a basic flash in it. But my truck is demandated. Mommaburt and I worked quite a bit to get the proper everything for this truck right. I have all the programs to pull anything off the old ECM (it still communicates just fine) (caltherm and Insite) i pulled the mommaburt file from the ECM. I am lost after that. The new ECM wont be down to me to put on the truck until probably close to 5-7pm EST today. If there are any kind souls on here that can help me it would be greatly appreciated. | |||
| « Next Oldest | Next Newest » |
| Messages In This Thread |
Flash old ecm to new ECM - Chamberpains - Yesterday RE: Flash old ecm to new ECM - tree98 - Yesterday, RE: Flash old ecm to new ECM - Chamberpains - Yesterday, RE: Flash old ecm to new ECM - Chamberpains - Yesterday, RE: Flash old ecm to new ECM - Chamberpains - Yesterday, RE: Flash old ecm to new ECM - tree98 - Yesterday, RE: Flash old ecm to new ECM - Rawze - Yesterday, RE: Flash old ecm to new ECM - Chamberpains - Yesterday, RE: Flash old ecm to new ECM - tree98 - Yesterday, RE: Flash old ecm to new ECM - Mrkentee - Today, |
NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.