cnc mill repairs

[Rawze]

(From What I can see, the beer is talkin' )...

Unless there is stuffs that I cannot see in the photos ... those FANUC drives are doomed to fail / fail again. That motion control system cabinet is not designed correctly. There are missing support components for those drives either because the maker of that CNC was a cheap-scate, and tried to cheat the system, putting those drives at risk ... That, or they were absolute dumb-arsses and don't know how to design a CNC mill motion control system properly.

The irony is that they almost got part of it right on the front-end .. but then they cheaped out on the things that counted the most towards protecting those drives properly.

- I.E.> WTF good is it to put a line reactor without proper amp-traps in the system to go with it? .... WTF???!!> .. and WHERE THE H@#ELL is the dynamic braking unit?>> WTF!!?>>. Any feed-rate above 30-40% on the table with a heavy part is going to torture those drives every time it reverses direction!.

WHO makes this machine?.. some back-water third rate CNC tooling company?. <-- because I sure hope like all s#ell that it is not a major brand doing things this badly. That F$in thing looks like the inside of some teen-age kids science project.. and not a professional CNC controls system cabinet design at all.