X15E3 CM2350 Cruise Control fault

[Rawze]

(06-30-2026 )Rawze Wrote:  

(06-29-2026 )BAMtech Wrote:  Thanks for getting back to me Rawze, yes I have ecm backup with Cterm before and after programming, can I compare these 2 files to see if anything has been missed with Cterm? Or is this something you would need to look at?

If you have both before it was touched, then a fresh backup form after, then e-mail them to me.. I can look and likely spot what went missing fairly easily. I PM'd you my e-mail address.

Of the 2 files that you sent me,.. they both have the same settings in them for cruise, etc.

It looks like the settings are missing from before you took your first backup via CT.

If the vehicle settings have been unfortunately lost forever, there is only one way to get them back. Blank out the ECM so that the incorrect/missing cannot be re-used, and take it to the stealers%$it for the truck make and have them recovered to original factory settings from when the truck was built.

- Again, this is why I always encourage someone to make a full backup of the ECM via CT software before anyone touches it.