Dyno Translation
01-16-2018, (Subject: Dyno Translation ) 
Post: #12
RE: Dyno Translation
Noticed something that aint the best. On the page that has the info from after the dyno run it shows oil pressure at 14 psi. Kinda low but the again it was idling below 600 rpm. Also it shows the percent load at 6%. Not good. You may have fueling actuators worn out or needing attention.
replyreply
 Thanks given by: Grizzly , Rawze


Messages In This Thread
Dyno Translation - Grizzly - 01-15-2018,
RE: Dyno Translation - Rawze - 01-15-2018,
RE: Dyno Translation - Grizzly - 01-15-2018,
RE: Dyno Translation - Grizzly - 01-15-2018,
RE: Dyno Translation - JMBT - 01-15-2018,
RE: Dyno Translation - Grizzly - 01-17-2018,
RE: Dyno Translation - Rawze - 01-15-2018,
RE: Dyno Translation - Grizzly - 01-15-2018,
RE: Dyno Translation - Grizzly - 01-15-2018,
RE: Dyno Translation - Rawze - 01-15-2018,
RE: Dyno Translation - Grizzly - 01-15-2018,
RE: Dyno Translation - Starlight - 01-16-2018
RE: Dyno Translation - Grizzly - 01-16-2018,



NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.