Dyno Translation
01-16-2018, (Subject: Dyno Translation ) 
Post: #13
RE: Dyno Translation
(01-16-2018 )Starlight Wrote:  Noticed something that aint the best. On the page that has the info from after the dyno run it shows oil pressure at 14 psi. Kinda low but the again it was idling below 600 rpm. Also it shows the percent load at 6%. Not good. You may have fueling actuators worn out or needing attention.

Thats odd, because I had all new injectors and actuators replaced back in April 2017. Wonder if I got another bad part.
replyreply


Messages In This Thread
Dyno Translation - Grizzly - 01-15-2018,
RE: Dyno Translation - Rawze - 01-15-2018,
RE: Dyno Translation - Grizzly - 01-15-2018,
RE: Dyno Translation - Grizzly - 01-15-2018,
RE: Dyno Translation - JMBT - 01-15-2018,
RE: Dyno Translation - Grizzly - 01-17-2018,
RE: Dyno Translation - Rawze - 01-15-2018,
RE: Dyno Translation - Grizzly - 01-15-2018,
RE: Dyno Translation - Grizzly - 01-15-2018,
RE: Dyno Translation - Rawze - 01-15-2018,
RE: Dyno Translation - Grizzly - 01-15-2018,
RE: Dyno Translation - Grizzly - 01-16-2018



NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.