King pins tools

[dhirocz]

I replaced my kingpins and used no special tools aside from a brake hone and a socket, I think it was a 34mm, that fit perfectly to tap out the old bushings... I used the keiser setup and I love it...

Just make sure you read the directions carefully. You want to make sure you reassemble everything correctly.

Now if I only had an easier way of pulling and installing bearing races and spring eye bushings I'd be all set!

I do agree that you need to make sure that you torque your fasteners to spec and check lash where appropriate. I don't consider these kind of tools to be 'special'. Just make sure if you do it, it's legit and correct.

I also made a point to change all my cotter pins and whatnot while I was down there.