CM 871 help please

[shoe128]

(12-27-2018 )Roysbigtoys Wrote:  

(12-26-2018 )Ryeguy475 Wrote:  Hello,
I own a 2009 871 450hp. It has a vibration under load that I just cannot seem to solve. When it’s parked I can rev it up and it’s fine, unloaded it isn’t too bad until...I go up a hill. Loaded it’s worse. I know it’s coming from the engine. This is what I’ve done so far... in frame 90k miles ago. New vibration dampener 4 months ago, new motor mounts, new clutch, reman trans. I did the injector leak test that I learned from Rawze, found #6 was leaking, replaced that. Made no difference!! I did the leak test again to make sure and it passed, no bubbles. This thing is driving me insane! I found a local Cummins “guru” that worked for Cummins for 16 years, he plugged into it and went for a ride with me, he agreed the vibration was coming from the engine. It’s almost like a slight fuel knock or similar. He did the cyl cutout test and it passed. The only thing he saw that he didn’t like was fuel pressure was 240 idle and 265 under full load when I was pulling a hill. He thought that was low pressure. My fuel economy hasn’t changed since this vibration started 6 months ago.[/align] Any ideas or thoughts are appreciated!

I too had a engine vibration about 3 years ago ......or at least I thought so. It only vibrated when climbing elevations. It turned out to be the stupid transmission heat exchanger leaking anti freeze into the tranny and for some reason that caused my vibration. I took the stupid exchanger off, flushed it with the tranny with ATF, refilled with 80W90 and my problem went away.
This fall the tranny finally started giving me problems when shifting from hi/lo so I replaced my 13 spd with an 18 spd. I am now looking for a good air to air cooler that will mount right up to my 09' Pete 386...any suggestions?

not sure if you had and looking to replace or don't have and lookingto install
but maybe check this guys mine was 647.00 GENERAL RADIATOR.COM id call