Turbo Table Settings

[Lonestar10]

So finally checked my intake manifold air out of the port by the IMAP on CM871. my OEM boost gauge is sitting below 0 on the gauge basicaly on the peg. but when pulled the plug i get enough air to probably float a few peices of paper stacked ontop of eachother instead of just a flutter. my min table is 54% in the idle area and max is 59% in the idle area of 0-1000rpm and 0-75 fueling tables.


if ive understood correctly i should be looking for a flutter instead of a jet of air.

when i get to a flutter point do i need to adjust anything above the 0-1000rpm and 0-75 fueling or leave them be? and do i need to adjust both tables or just the one that makes the turbo open up more.

thanks for an input1