Cam help
04-14-2019, (Subject: Cam help ) 
Post: #9
RE: Cam help
Thanks good thread rawze. Truck is sitting till it gets overhauled in a few weeks. Guy has to finish up another one before he can start mine. While your videos are extremely helpful I don't think I'll tackle it by myself just yet! Plus I'm getting swamped with work and can run the old truck to make money to pay for new one!
Thanks for all the info it's made finding the right guy for the job much easier.

For piece of mind I'm going to replace everything on the top end. That way I know it's been properly taken care of. When I was at parts dealer they didn't have any new heads available but from what I've read some heads say the are recon. But are stamped with new part numbers is this correct?
I went to school with parts guy so he would probably check the heads for me.

Since I have a few weeks before we start it I can afford to look around for a new one. If someone can point me in the direction of new heads that'd be great!!
Thanks for the help


User's Signature: 2010 kenworth t800 isx500hp cm871 13spd 3.55ratio
replyreply


Messages In This Thread
Cam help - Scoot5869 - 04-12-2019,
RE: Cam help - Scoot5869 - 04-12-2019,
RE: Cam help - Scoot5869 - 04-12-2019,
RE: Cam help - Scoot5869 - 04-12-2019,
RE: Cam help - Unilevers - 04-12-2019,
RE: Cam help - Scoot5869 - 04-12-2019,
RE: Cam help - Lonestar10 - 04-12-2019,
RE: Cam help - Rawze - 04-13-2019,
RE: Cam help - Scoot5869 - 04-14-2019



NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.