Rawze.com: Rawze's ISX Technical Discussion and more / Big Truck Technical Discussion... / Ask Your question... / JAKE ADJUSTMENT ON ISX

new reply
JAKE ADJUSTMENT ON ISX
07-14-2019, (Subject: JAKE ADJUSTMENT ON ISX ) 
Post: #19
Rawze Offline
Forum Reject  (13888 Likes)  *******

 		Posts: 10,968
Joined: Jun 2013
Thanks: 5875
Given 13888 thank(s) in 6060 post(s)
RE: JAKE ADJUSTMENT ON ISX
(07-13-2019 )DosGatos Wrote:  Did the overhead from scratch; loosened up everything but didn't remove the shafts. I have about 60k on the new rocker shafts and had rotated the shafts. Don't keep notes so no clue what happened when I installed the replacement shafts.
Following the instructions starting with the flat ends set to the block and final torque to 90lb I have a consistent .090 +,- running clearance. Odometer is 835k so was expecting less. Looking over the head I see all the freeze plugs are unpainted. Can only guess the head was rebuilt but I have no service records from the original fleet or second owner.

that is much better. When they start getting below 0.030" travel from the detent position to the top of the valve stem, its time to replace the head.

User's Signature: ->: What I post is just my own thoughts and Opinions! --- I AM Full Of S__T!.
Return to Top | find
replyreply
new reply


Messages In This Thread
RE: JAKE ADJUSTMENT ON ISX - Unilevers - 07-01-2019,
RE: JAKE ADJUSTMENT ON ISX - Rawze - 07-14-2019



NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.
Theme by MyBB Addict
Contact Us | Rawze.com | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication