Load Based Speed Control Issue

[Unilevers]

(10-19-2019 )Signature620 Wrote:  At 120,000lb, the LBSC will not have any effect. It only limits max engine speed at low load.

im sorry but this is very much not true. It hinders it greatly especially if the settings are set lower for high and low breakpoints. there is also a software glitch in some of the calibrations that even if LBSC is turned off it still adheres to the upper break point. To truly make 100% sure its off raise the breakpoints to above your RPM range and then turn off LBSC interaction/enable.