Load Based Speed Control Issue

[SquareOne]

Would anyone know all the LBSC breakpoints which need to be raised for an X15 in CT? I see a few years back where Unilevers mentioned the breakpoint glitch, but I'm still having the LBSC affect my pulls.

I've raised all the high breakpoints to 2100 rpm (from 1800rpm), but there are also some Low 'high' breakpoint settings as well (This is how it's labeled in CT). These are set to 1400rpm and since I'm not familiar with them I left them alone. Even with the LBSC disabled and the high breakpoints raised to 2100rpm, I'm still hitting a damn wall under load at 1800rpm. Just not sure where I'm falling short at.

The Engine protection tab is locked on my ECM so I can't use Insite for this like my other truck.