Pressure testing CM870 |
11-03-2019, (Subject: Pressure testing CM870 ) Post: #14 | |||
| |||
RE: Pressure testing CM870 (11-03-2019 )Lonestar10 Wrote: I built all my tester out of pvc figured if the glues good for 60-90 psi water good enough for 20-30 of air. Just drilled/tapped the caps for pressure regulator then put a washer and retaining nut on inside of pipe on regulator then glued and clamped boots on them just a word of caution on PVC... Never ever assume that since PVC can hold 60 - 90 psi of water, will it hold the same in only air pressure. I have seen many many PVC pipes explode and it can put you in the hospital or kill someone. i goes off like a stick of dynamite. - seen that mistake so many times in machine and mechanics shops where they cheap out and use PVC for their air supply, it is not even funny. 20-30 psi, not too harmful, but don't expect it be anything near safe with higher pressures. User's Signature: ->: What I post is just my own thoughts and Opinions! --- I AM Full Of S__T!. | |||
|
« Next Oldest | Next Newest » |
NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.