Into the @m*m^2 |
05-05-2020, (Subject: Into the @m*m^2 ) Post: #4 | |||
| |||
RE: Into the @m*m^2 (05-05-2020 )Rawze Wrote: If your getting to 32 psi with only 50% throttle, then it likely needs to be adjusted to ensure it stays in check at full throttle. Some of those car haulers and their bigger CAC, etc. front ends can be a bit touchy to adjust sometimes. Just be sure not to push it past about 33 psi or so in the mean time, till you can get it re-adjusted. The CM2350's can't handle above 33 psi or so of boost without it causing some harm to the engine. This is because the aspirated compression ratio is already so high on them that they do not need very much extra boost to make full power. I haven’t the foggiest how to make that adjustment so in the mean time I’ll keep a close watch on to ensure that I don’t stress it’s limit until I can get out to GA for some like yourself or Mr Hag to look at it properly. | |||
« Next Oldest | Next Newest » |
NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.