Need some guidance
06-25-2020, (Subject: Need some guidance ) 
Post: #15
RE: Need some guidance
(06-25-2020 )Lonestar10 Wrote:  I don't think there's any electric valves that shut off the freon to the monks of the AC is running Freon should be running through the EVAP unless the orifice or whatever Tube is plugged so if you're getting heat with the AC on most likely the blend door is swung the wrong way. if you have a normal international I'm not quite sure if you have one that has the no idle AC.
I was half asleep last night, I meant the expansion valve in the floor. The line going in and out is hot. There is one bolt in the center and I hear they like to break. I replaced everything up front, pump, dryer, expansion valve, and the two thermistors. Right after that the bunk stopped, it probably got clogged up.
replyreply


Messages In This Thread
Need some guidance - Ricky - 06-23-2020,
RE: Need some guidance - JimT - 06-23-2020,
RE: Need some guidance - Rawze - 06-24-2020,
RE: Need some guidance - Ricky - 06-24-2020,
RE: Need some guidance - Ricky - 06-24-2020,
RE: Need some guidance - Ricky - 06-25-2020,
RE: Need some guidance - Ricky - 06-25-2020,
RE: Need some guidance - Ricky - 06-25-2020
RE: Need some guidance - Ricky - 07-12-2020,
RE: Need some guidance - Ricky - 12-09-2020,
RE: Need some guidance - Ricky - 12-09-2020,
RE: Need some guidance - Ricky - 12-09-2020,
RE: Need some guidance - Ricky - 01-22-2021,
RE: Need some guidance - Ricky - 01-22-2021,
RE: Need some guidance - Nilao - 01-22-2021,
RE: Need some guidance - Ricky - 01-22-2021,
RE: Need some guidance - Nilao - 01-23-2021,
RE: Need some guidance - Nilao - 01-23-2021,



NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.