@m*m^2 tune

[Canadian_eh85]

Hey y’all I am just looking if someone could pm the info of one of the guys close to me that does the @m*m^2 tunes. I live up near Edmonton Alberta Canada. Before I had found this sight I had deleted my truck with a CM870 CpL 8518 and did all the work myself (cause I refuse to pay someone to do something I can do myself) putting a full tilt manifold and that “most loved”(hated) bw 171702 turbo. I did upgrade my Cam with a higher lift and duration on the exhaust to get my jakes back. Again like I said all before I found y’all and didn’t know better. I have had it custom tuned by what I would consider a very good turner here who widen my torque band up into the 1700rpm range since I never run my motor loaded below 1500rpms. It’s tuned up around 750hp. I am running it through a Mack maxi torque 18speed tranny and Tri drive Rockwell 4:33 rears with 22.5 rubber. I am pulling 140,000lbs off road lots. I know the tune is a good tune cause I can never get over 915° on the pyro and the engine is very smooth running with no vibrations when working it hard.

I guess my question is now that I have learned a lot from reading in this group would the @m*m^2 tune still be worth going for with the current setup I have. After spending the money I had on the upgrade/downgrade I dont want to just throw that money away too. Basically am I too late at this stage?? Please go easy on me as I am the first to admit my mistakes after coming to the light.

Also one of the other reasons I am asking too is I have some good friends that have 2 trucks with an cm870 and an a cm871 that I have been telling about the @m*m^2 tune. They like me had done the full deletes but unlike me who at least has a some what good tune theirs were pukedits tunes with with the big boss crap. My truck is very smooth on the power where theirs are really rough on the power to the point they doing like using it cause it vibrates too much...... fast forward to a couple days ago and they snapped a crank in there truck. Right now seeing as they are farmers and really busy I have been helping them work on rebuilding the motor and have been preaching Rawze to them and they agree that the pukedits tunes are carp and would like to look into the @m*m^2 ask they are now seeing the light on this stuff. So any help you guys can give would be great. They still have their VGT turbo and would be will to put it back on too now. So I think we may have a few more converts. Thanks in advance for any help you can give.

Cheers!! Elliot.