Cam replacement cm2350 |
12-10-2020, (Subject: Cam replacement cm2350 ) Post: #2 | |||
| |||
RE: Cam replacement cm2350 Since you put a new cam in, the wear surface on it will be new, and that means all the measurements will more than likely be off. I would skip checking lash and readjust all the valves to Cummins spec using the T handle torque wrench method listed on QuickServe. That is if you have that torque wrench. I never noticed excess wear or noise on the fleet of 2250 and 2350s I maintained using this method but I would have to ask Rawze about that. {part of post removed. Bad information}. | |||
|
« Next Oldest | Next Newest » |
Messages In This Thread |
Cam replacement cm2350 - SemiSweet - 12-10-2020, RE: Cam replacement cm2350 - Coronado126 - 12-10-2020 RE: Cam replacement cm2350 - SemiSweet - 12-10-2020, RE: Cam replacement cm2350 - Rawze - 12-10-2020, RE: Cam replacement cm2350 - SemiSweet - 12-10-2020, RE: Cam replacement cm2350 - Waterloo - 12-10-2020, RE: Cam replacement cm2350 - Rawze - 12-10-2020, |
NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.