Cam bearings

new reply

Threaded Mode | Linear Mode

Cam bearings

07-30-2016, (Subject: Cam bearings )

Post: #25

overshot Offline

HMR- Contributing Memeber (25 Likes)

Posts: 135
Joined: Feb 2016

Thanks: 179
Given 25 thank(s) in 14 post(s)

RE: Cam bearings

(07-28-2016 )jimeneztrans84 Wrote: Where did you get that fitting that screws on the side of the block? Size?

The size for the fitting in the oil cooler is M14 to #8 jic
Return line into the block is M18 to #8 jic. You can get them at some hydraulic stores. I prefer steel fitting.
Be sure not to over torque them.

Tags:

bypass oil fittings,bypass,oil bypass,oil plugs

Return to Top | find

reply reply

« Next Oldest | Next Newest »

new reply

Messages In This Thread

Cam bearings - gatow900 - 07-27-2016,

RE: Cam bearings - Vin - 07-27-2016,

RE: Cam bearings - Rawze - 07-27-2016,

RE: Cam bearings - gatow900 - 07-27-2016,

RE: Cam bearings - Rawze - 07-27-2016,

RE: Cam bearings - gatow900 - 07-27-2016,

RE: Cam bearings - Wiseman - 07-28-2016,

RE: Cam bearings - simon999 - 07-28-2016,

RE: Cam bearings - Rawze - 07-28-2016,

RE: Cam bearings - jimeneztrans84 - 07-27-2016,

RE: Cam bearings - Wiseman - 07-28-2016,

RE: Cam bearings - snailexpress - 07-28-2016,

RE: Cam bearings - yamajason - 07-28-2016,

RE: Cam bearings - gatow900 - 07-28-2016,

RE: Cam bearings - jimeneztrans84 - 07-28-2016,

RE: Cam bearings - Vin - 07-28-2016,

RE: Cam bearings - Wiseman - 07-28-2016,

RE: Cam bearings - jimeneztrans84 - 07-28-2016,

RE: Cam bearings - Wiseman - 07-28-2016,

RE: Cam bearings - yamajason - 07-28-2016,

RE: Cam bearings - Wiseman - 07-28-2016,

RE: Cam bearings - jimeneztrans84 - 07-28-2016,

RE: Cam bearings - overshot - 07-28-2016,

RE: Cam bearings - jimeneztrans84 - 07-28-2016,

RE: Cam bearings - overshot - 07-30-2016

NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.