High boost
01-13-2021, (Subject: High boost ) 
Post: #3
RE: High boost
(01-13-2021 )Rawze Wrote:  anything much more than 33 psi or so will kill a 2350. That needs to be fixed right away.

Has it been like this since the programming was done? -- or did it change suddenly?

If it suddenly changed...
Maybe do a turbo inspection to see if it has full range of operation ... and make sure the turbo passes a calibration test.

If it has been like this since the programming...
If all is well with the system then have whoever made the program lower the boost tables to bring it back in spec, simple as that.

it had been around 35-36 ish factory gauge is a little hard to tell since the programing. it was higher close to 38 with the mandate intact. it seems to be higher here lately that's why I changed the map sensor thinking it was just reading incorrectly it had been in about 100K. ran a leak down had a injector leaking that I replaced still the same results. I am parked so I went ahead and ran a calibration test it passed. I will inspect the turbo its self when the sun comes up and I can see better and let you know the results
replyreply


Messages In This Thread
High boost - Yauchout - 01-12-2021,
RE: High boost - Rawze - 01-13-2021,
RE: High boost - Yauchout - 01-13-2021
RE: High boost - Rawze - 01-13-2021,
RE: High boost - Yauchout - 01-13-2021,
RE: High boost - Slowmotion - 03-15-2021,
RE: High boost - tree98 - 03-15-2021,
RE: High boost - smorgan87 - 03-15-2021,




  
  
Theme by MyBB Addict
Contact Us | Rawze.com | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication