Cm871 tune up

[Rawze]

After a million miles and no one did the rod and main bearings back at around the 800k mark (or equivalent engine hours) ... It starts to become a ticking time-bomb for sudden wrist pin failure. It is one of the more well-known things that the ISX will do if someone keeps driving one blindly, expecting it to last forever.

For a CM871, The more miles above about 1 mil or so (this would be 1.2 mil for a CM570 or CM870), the higher the gamble of it throwing a piston straight thru the side of the engine block without any warning whatsoever. Engine = boat anchor if this happens and there is no fixing it.

That is why the comments by others has been said. It has been seen around here before.... so yeah .. its time to take it to pasture and inframe it at that 1 mil miles or so. You'de be doing good to maybe get it to 1.1 or 1.2 mil but would be at a very high risk at that point. Some people get real lucky and get more than that but it is the exception, not the rule, and should not be relied on.

de-manding it will loosen all the carbon packing up and open up the ring clearances, etc.... so the risk is even higher for sudden high blo-by or a wrist pin failure at that age as well.

Like others mentioned ... inframe it first ... do all the stuff talked about to extend its life during the inframe .. and then after that (or during) would be the time proper time to do any mods to it, not before. Just be lucky that you did an EGR tune-up on it and got it running well again in the mean time.