Cummins ISX Injector Trim Codes

[Rawze]

The older Insite 7.6.2-SP5 allows the trim codes to be put in manually for CM2350's. It is under the "Advanced Data-> High Pressure Injector Setup"

The Newer Insite 8.5 and above has this option of automatically allowing the ecm to calculate them with a "Reset" option instead of putting them in manually.

It is unclear if all CM2350's support this. There are 2 different tiers of the CM2350 ecm,.. so this option may only be available on the newer ones.. however this is unconfirmed.


That is what is known so far any ways.

Just spoke to Mr. Hag on this and he said that he typically uses the older Insite 7.6.2-SP5 to put in injector trim codes whenever possible, unless he is forced to use the newer Insite8.5 method on one.