EGTs and Gauge

[Rawze]

(10-25-2021 )NDISX15 Wrote:  

(10-14-2021 )Rawze Wrote:  EGT's themselves is 1350f max for 3 mins. However your not measuring this if you did not install the probe into the exhaust stream itself.

Outer housing temp on the other hand is roughly 950f sustained on a long pull. Having Good air flow under the hood helps with this a lot too.


As far as shutting it down.. anything below about 350f on the outer housing and your fine.

EGT probe was installed into the manifold today, which now i have to change my train of thought on the gauge readings while driving pulling.....so if i understand this correctly......inside the manifold probe placement,max temp is 1350F sustained no longer than 3 min, correct?

Just dont wanna blow something up before can start dialing in the tuning here. Looking to try and do a custom tune to make this truck perform nicely for what it does 7 days a week.

If the programming was done right, then there should will be nothing to "dial in", except to only ensure that it is not capable of over-boosting vs. the model engine you have.

- It being a CM2250, this would be no more than 36-psi of boost, no matter how hard you push the thing up a long hill.

You should also ensure ...

* It does not have any boost leaks.
* It does not have any boost exhaust manifold leaks.
* The exhaust system is as free-flowing as possible.. (all cans including SCR unit have been 100% fully hollowed out).