Oil pan T joint sealants

[Nostalgic]

(12-25-2021 )Signature620 Wrote:  You can clean silicone mostly off, then add a touch of fresh silicone and reuse the gasket. Don't coat the entire gasket in anything apart from the corners.

Also, why are you removing your pan so often that this is even a concern for you??

Haven't been there yet, but shimming the pressure regulator on one of the new pumps and wanting to make an adjustment?

Or, if you have my luck and install a new strip gasket on your front cover and let the 1.5" piece you cut off slip out of your fingers. Little bugger made a clean shot past all of the gears and straight to the bottom of the oil pan.