2 codes after changing Imap sensor
09-23-2022, (Subject: 2 codes after changing Imap sensor ) 
Post: #6
RE: 2 codes after changing Imap sensor
It's a 2014 Kenworth T660, with an ISX15 CM2350 Inframe was done 100000 miles ago, turbo and actuator were replaced about 20000 miles ago. After replacing the one sensor and cleaning the other, I cleared the codes. The fault code was due to the IMAP sensor having too much soot. Coming up from ga last night, got the same check engine light and 25% loss power bs, took out the IMAP sensor and cleaned it. So far all is well, but I do have some questions....

When cleaning the intake, what would be the best way to clean it? I have carb/choke cleaner but dont know is it should use a brush on it.

I'm planning on doing the egr valve as well once i get back to jax, anything good I can use?
replyreply


Messages In This Thread
RE: 2 codes after changing Imap sensor - Hennessy - 09-23-2022



NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.