Block cutting, specific to ISX/X

[dericson]

(09-29-2022 )Rawze Wrote:  

(09-29-2022 )dericson Wrote:  ...
Do you happen to have a reference chart for cut specs and shims handy? I found something floating around and wanted to check the validity of it. I can’t remember exactly where it was from. I added it as a file

ref: http://rawze.com/forums/showthread.php?t...9#pid28349

I corrected your post... and yes, those are the numbers that I typically go by when doing one.

We’ll look at that. You strike again. Must have been copy and pasted elsewhere. I was going to say that maybe I got it off this forum but then the webpage background looked different. Oh well. Anywho. Thanks buddy!